Automatically generate constraint maps to identify the actual buildable area for each parcel or site. This tool lets you analyze multiple parcels, helping you quickly focus on the most suitable ones for development.
Before you begin
Before running a buildable area analysis, ensure you have completed the following:
- Add parcels and create a site.
- Set up parameter templates (optional): Customize and save your buildable area templates in PVcase Prospect. Saved templates automatically sync and become available for use in PVcase Concept.
Running buildable analysis
You can run a buildable analysis in either PVcase Prospect or PVcase Concept. If you run the analysis in PVcase Prospect, the data will automatically populate in PVcase Concept once you start working on a selected site. If you chose to run it in PVcase Concept, follow the steps below.
To run a buildable analysis:
- Go to Buildable Area on the left sidebar in PVcase Concept.
- Select a parameter template or enter your settings manually.
- Click Run Buildable Area Analysis.
- Review your results on the map and the summary pane on the left.
Tip: Ensure all required hazard layers are enabled in your parameters before running the analysis, as disabled hazards will not calculate setbacks.
FAQs
How long does it take to run buildable area analysis?
Each parcel's analysis usually takes a few seconds, depending on size and topography. A large project with hundreds of parcels may take several minutes to produce results.
What if the analysis is taking too long?
If the analysis fails or takes longer than expected, refresh the page and let the system reload. If the issue persists, please report it to our Customer Support team at support@pvcase.com.
What should I do if the analysis fails?
If the analysis fails, it is usually due to the selected parameters. You will receive an error message detailing the issue. Try adjusting the parameters and running the analysis again. If the issue persists or you need assistance, please contact our support team at support@pvcase.com.
Why are certain layers or setbacks missing from my results?
Make sure the required layers are enabled in your parameter settings before running the analysis. Disabled hazards will not have their setbacks calculated.