Review your site's buildable area, rerun the analysis with different settings, and edit the results by hand. Concept shows your buildable area as a percentage of the lot size.
Before you begin
Open the site and review its measurement units. If the site already has Buildable area analysis results from Prospect, review those results before making manual changes.
For Prospect users: Set up parameter templates (optional). Save your templates in PVcase Prospect—they sync to Concept automatically.
Automated analysis requires PVcase Prospect with purchased layers for your region. Otherwise, define buildable areas by drawing exclusions manually or reclassifying imported polygons.
Viewing the analysis
If you ran the buildable area analysis in Prospect, the restrictions and overlays import into Concept with your site automatically. On the map, the buildable area is green. Exclusions are colored by type—exclusions in red are user restrictions (added manually or reclassified), while other colors come from the automated analysis.
Rerunning the analysis with new settings (Prospect users)
In Concept, click Buildable Area in the left sidebar.
Click Adjust Settings.
Select a template saved in Prospect, or enter your own settings.
Change the parameters you need.
Click Run analysis.
When asked whether to save your existing analysis, click Continue without saving, or click Save scenario, enter a name, and click Save.
Make sure all the hazard layers you need are enabled in your parameters. Disabled hazards don't get setbacks calculated.
Editing the buildable area manually (All users)
Use manual editing to exclude features the automated analysis missed (such as roads), define restrictions when automated layers aren't available, or add land back into your buildable area.
1. Enter edit mode
Click Edit at the top of the screen, or click Edit > Edit manually at the bottom of the Buildable Area tab.
2. Refine the area using any of these tools:
Draw a line: Click along the path, double-click to finish, set the Radius to define the exclusion width (for example, 6 m), then name and save it.
Add restriction: Click around the perimeter to draw a polygon, click to finish, and name the exclusion.
Add buildable area: Reclaim land—for example, on top of a previous exclusion. Draw the area you want to include back in the buildable zone.
-
Offset: Adjust the inward offset in the top-right corner to preview how the boundary shifts. (Note: The buildable area only updates if the new setting affects land within your site.)
3. Manage existing exclusions (optional)
Any manual or reclassified exclusions appear under User restrictions. Select an item to disable it (which returns that land to your buildable area) or delete it permanently.
4. Save or discard:
Click Save changes to apply your edits. To step back while editing, use Undo, or click Cancel to discard all unsaved changes.
If you imported existing site polygons (such as boundaries or CAD/KML shapes), select the polygon and reclassify it as a User restriction (or another appropriate category) to automatically subtract it from your buildable area.
FAQs
How long does it take to run buildable area analysis?
Each parcel's analysis usually takes a few seconds, depending on size and topography. A large project with hundreds of parcels may take several minutes to produce results.
What if the analysis is taking too long?
If the analysis fails or takes longer than expected, refresh the page and let the system reload. If the issue persists, please report it to our Customer Support team at support@pvcase.com.
What should I do if the analysis fails?
If the analysis fails, it is usually due to the selected parameters. You will receive an error message detailing the issue. Try adjusting the parameters and running the analysis again. If the issue persists or you need assistance, please contact our support team at support@pvcase.com.
Why are certain layers or setbacks missing from my results?
Make sure the required layers are enabled in your parameter settings before running the analysis. Disabled hazards will not have their setbacks calculated.